![]() 15 on "eno1" and three inet6 addresses, but apart from that the result is quite the same as with above "ip"-hack. I will try netctl, though.Īnd right now I have booted with systemd and have dhcpcd started. Maybe I was lucky, but it is good news that you can hack around under systemd and inet6. 16 in my address is just any (free) number, and 192.168.0.1 should always be the gateway. #Virtualbox network is unreachable linux install#e1000e 0000:00:1f.6 eth0: Intel(R) PRO/1000 Network Connection Unreachable network on fresh install on VirtualBox Ive recentyl sarted the journey of being an arch linux user. With a working ping and the mirrorlist in /etc/pacman.d/ you have all you need for pacman or pacstrap.Īnd yes, I saw a kernel message renaming eth0 to enoxxx, so you have to check first with "ip link" what interfaces are already set up by systemd. And you can stop it cleanly with "dhcpcd -x". So this is instructive, but "dhcpcd" is faster to type, and probably more robust. It took me quite some time to test this out (ip link help, ip address help, ip route help.). The "ip" commands activate the link, choose an address and define a local (subnet) and then a default gateway. When using 'NAT' I get a lot of 'link down' events. When i change the network settings in VirtualBox to 'NAT-Network' everything works fine. #Virtualbox network is unreachable linux 64 Bit#By loading this module I get a eth0 link (no, don't look for it in /dev). I have the same problem here, with a Windows 7 64 bit host and Kali Linux and Fedora 21 as guest. Instead of using dhcpcd, I can also connect from zero with: modprobe e1000eĮ1000e is a "Network Driver", says modinfo. ![]() ![]() I even used "watch ip address" to see how fast these inet and inet6 addresses pop up. Just type "dhcpcd" as a command, wait a few seconds, and then "ip route" or "ping 8.8.8.8" to check if it works. This worked on the spot for me AFTER installation. Archlinux says, try dhcpcd in case your installer can't connect automatically.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |